What should I do if the automatic sealing machine encounters a card box?

Firstly, it may be due to the small adjustment of the width or height of the sealing machine, as the machine manually adjusts the corresponding width and height during the transportation of cardboard boxes. Therefore, there will always be some deviation, resulting in the height and width not being able to reach a good level, causing the cardboard boxes to not match the sealing machine and resulting in box jamming. The solution to this problem is to first place the cardboard box on the workbench of the sealing machine, and then adjust the height and width of the machine according to the size of the cardboard box.

Secondly, due to the light weight of the cardboard box, it cannot pass through the movement. The principle of sealing tape with an automatic sealing machine is to press the cardboard box with the sealing machine, and then impact the tape guide roller during transportation, thereby achieving automatic sealing of the tape on the cardboard box. However, due to the light weight of the cardboard box, it is difficult to fit the tape guide roller, resulting in the phenomenon of box jamming. However, this phenomenon is relatively rare because there are products inside the cardboard boxes, and the specifications of the cardboard boxes are based on standards, and the design is also arranged reasonably.

Then, because the tape was not cut in time, after using the automatic sealing machine for a period of time, a lot of debris and dust from the tape will stick to the cutting blade, which will cause the cutting blade to be not sharp enough to cut through the tape, and the continuous cutting of the tape will cause the cardboard box to get stuck in the sealing machine and cannot continue to be transported. The natural solution to this problem is to clean or replace the cutting blade.

Article source: Jiangmen Packaging Equipmenthttp://www.jmhuiyu.com/