The use of fully active packaging assembly lines is becoming increasingly common, with large-scale enterprises in various industries having such lines. However, due to poor cardboard boxes, problems such as box sealing machine jamming and production difficulties have always plagued businesses using fully active packaging assembly lines, and some cardboard packaging factories have even lost customers as a result. Here are a few suggestions for everyone to improve.

Flatness of cardboard boxes

When producing cardboard boxes, they must be flat because bent cardboard boxes easily get stuck when entering the sealing machine assembly line equipment, and affect the subsequent cardboard boxes entering the machine and causing damage, resulting in the active assembly line stopping, high box breakage rate, and high loss of cardboard boxes. Therefore, attention should be paid to the cardboard boxes used in the production of active packaging assembly lines.

The creases on the surface of the cardboard box

Because the formation of cardboard boxes relies on suction cups, if there are creases on the surface of the cardboard box, the suction cups will leak air, causing the cardboard box to fail to form and jam the machine. The main causes of creases are mold and handling issues, as well as creases caused by cardboard bending.

The size of the cardboard box should be accurate

Because the gaps and folding points of the active packaging assembly line are set according to the standard dimensions of the cardboard boxes, if there is a large deviation in the dimensions of the cardboard boxes during the packaging process, folding misalignment and other situations may occur, and even cause the machine to jam.

Indentation line

The pressure line of the cardboard box should be deep. If the pressure line of the cardboard box is too shallow during the packaging process, it will cause the pressure line to not fold down or not fold on the pressure line, resulting in poor or impossible molding of the cardboard box.

Planning of shaking lid scale

When planning the size of the cardboard box shaking cover, attention should be paid to avoiding overlapping, and a gap of about 2mm should be planned as much as possible, which only needs to have an effect on the sealing of the active packaging assembly line.

The size of the carton seam and the difference in scissors

Because the size of the cardboard box seams and the difference in the scissors directly affect the forming of the cardboard box, poor forming can result in an ugly appearance of the cardboard box, and even cause the machine to jam and stop production. If these two problems are not handled properly, it is also a headache.

Adhesive overflow at the junction of the cardboard box

If there is glue overflow in the cardboard box, the suction cups of the active packaging assembly line will not be able to open the cardboard box, directly causing the sealing machine to jam and stop production. Therefore, this issue is something that cardboard box manufacturers need to pay attention to.

Article source: Jiangmen Houdao Packaging Production Linehttp://www.jmhuiyu.com/